Sound familiar?Cedar Harbour
- The call
- Someone smashed the little window beside the door, reached in and turned the thumb-turn. The lock itself is fine, but there is glass on the mat, a hole in the sidelight and a deadbolt anyone can reach.
You came home to find the front door standing open. The deadbolt is still thrown, but the strike plate is dangling from one screw and a fist-sized piece of the jamb is lying on the hall floor.
In plain words
A failed break-in is still a repair. When a lock holds against a pry bar or a kick, the force goes somewhere: a strike plate bends, screws loosen, the door edge takes a gouge, the deadbolt binds where the bolt met the strike under load. Left alone, that door locks a little worse each week and the next attempt starts from where the first one finished. The visit checks every part that took the strain, replaces what bent, reinforces the strike and hinges with long screws and confirms the bolt throws cleanly again. It is also the moment to add what would have made the attempt pointless from the start.
Break-In Damage Lock Repair · Cedar Harbour
How the visit goes
Scene 1
Who is asking, and is the scene clear
The first minutes are about people, not hardware. The locksmith confirms that the caller has authority over the property: photo identification with the address, a lease, an ownership record or an instruction from the property manager. A break-in is precisely the moment a stranger could ask for a lock to be changed, so the check protects the household. The second question is whether anyone is hurt and whether the intruder is certainly gone; if the police have not yet been called, that call comes before any work, and the door is left as found until they say the scene is released. Only then does the assessment of the opening begin.
Scene 2
Strengthening the door edge and hinges
Where a pry bar crushed the edge or the wood split around the lock bore, a wrap-around reinforcer is fitted: a steel channel that sleeves the door edge at the lock, ties the two faces together and gives the bolt and latch a solid seat. On the hinge side, the short factory screws are swapped for three-inch screws that reach the framing, and a bent hinge is replaced. Doors that were kicked hard sometimes need a hinge reinforcement plate across the jamb to spread the load. With both edges strengthened, the door no longer has a soft side, and a future kick meets steel and stud at every point that matters.
Scene 3
What another trade still needs to do
Locksmith hardware fixes a great deal, but a shattered frame, a broken door slab or a smashed sidelight belongs to a carpenter, door installer or glazier. When that is the case you leave with the opening secured, a clear list of what the other trade needs to do, and hardware chosen so it transfers to the new frame or door rather than being bought twice. The temporary securing is designed to hold comfortably until that work is booked. Insurers let you choose your own contractor, so the list is written for whoever you pick, and the locksmith is available to fit the final hardware once the woodwork is done.
In the van
- Anti-lift blocks and foot bolt
- Rekeying pins and key blanks
- Security strike box
- Plywood and cleats for boarding
- Two-part wood epoxy and shims
What shapes the quoteBell Ewart Lock Services
- Door edge reinforcement
- A wrap-around edge reinforcer is added when the wood around the bore is crushed or split. It is a separate part, chosen to suit the door thickness and the hardware going into it.
- Matching finish and style
- Choosing hardware that matches the existing trim, finish and handle style on your other doors can mean ordering rather than fitting from stock, which the quote notes.
- Distance to the property
- Travel is part of every emergency call, and a property well outside the usual service area involves more driving time, which appears in the quote.
FeesSame any hour
Ask us anything about locks
Will my door be boarded up, or can it be made to lock tonight?
Most forced doors lock again during the visit. If the slab and frame are sound, a new lockset goes in and the strike is reinforced. If the jamb is split, a repair plate or a boxed strike screwed into the stud usually holds it. Boarding is reserved for openings where the frame or the door itself is destroyed, and even then it is fitted so the household can get out from inside without a key.
Can a split jamb be repaired, or does it need replacing?
Many can be repaired. A split along the grain is pressed back together, glued with a two-part wood epoxy and held by a steel repair plate or a boxed strike screwed through it into the stud, so the fasteners reinforce the repair as well as the lock. Missing wood is built up with filler or a fitted piece. A jamb that has pulled off the framing along its length or shattered around the pocket is replaced by a carpenter, with the opening secured until then.
Should I keep the broken lock and strike?
Yes, unless the insurer has already said they are not needed. Insurers generally ask policyholders to retain damaged property until the claim is settled, and a bag holding the twisted cylinder, torn strike and split wood answers an adjuster's questions more clearly than any description. The locksmith hands them over at the end of the visit along with a written note of what was replaced. Photographs of the parts in place, before removal, complete the record.
Lockout Services
- Business Lockout ServiceA cook stepped into the alley with the recycling and the rear door swung shut behind him.
- Broken Key ExtractionThe padlock on the shed has been stiff all summer.
- Seized & Jammed Lock OpeningIt is the coldest morning of the winter and the key goes halfway into the side door and stops.
- Lost Keys — Same-Visit RekeyYour purse was taken from the back of a chair at a restaurant.
Cedar Harbourinformation
SimcoeOntario
Break-In Damage Lock Repair · Innisfil, Bell Ewart, Big Bay Point, Cookstown, Innisfil Park, Killarney Beach, Leonards Beach, Nantyr Park, Stroud, Alcona, Alderslea, Bear Point, Belle Air Beach, Big Cedar Point, Cedar Mount, Churchill, Crescent Harbour, De Grassi Point, Glenwood Beach, Lefroy, Mooselanka Beach, Peninsular Park, Sandy Cove, Tent City
- Town
- Cedar Harbour, Simcoe
- In business
- 24 years
- Hours
- Open 24/7
- Nights, weekends and holidays, same fees
- Phone
- (249) 315-0368
- Visits
- On-site assessment preferred. Request a visit or call.
2021 census: what it means at the door
Every square is one home in a hundred.
- 35 in 100 homes · mixed ages
- 90 in 100 homes · mostly houses
- About 35% of homes in Innisfil were built in 1980 or earlier, according to the 2021 Census.Where housing ages are mixed, some homes have never had a deadbolt and others have two. The visit starts with a look at what is already there, and the recommendation might be adding a lock on one house and simply tuning it on the next.
- Single-detached houses make up about 90% of homes in Innisfil (2021 Census).Where most homes are detached houses, each one has several exterior doors: front, side, back, garage entry, sometimes a walkout. Getting them all onto one key is the most requested job, and it usually takes a single visit.
Nearby
On-site assessment
Request a visit.
You came home to find the front door standing open.
(249) 315-0368, open 24/7.